Solvent basted industrial coating high filler viscosity reduction epoxy floor coating additives adhesive dispersant BYK111

Anjeka 6111 Industrial coating Oil Based high filler viscosity reduction epoxy floor coating additives adhesive dispersant BYK111

DESCRIPTION

Anjeka-6111 is a wetting and dispersing additive for solvent-borne and solvent-free coatings that improves pigment wetting, reduces the time required for the grinding process and stabilizes pigment dispersion.

PRODUCT DATA

Chemical composition: Copolymerized solution with acidic groups

Typical Physical and Chemical Data:

The data given on this data sheet are typical values, not product specifications.

Appearance Colorless to light yellow liquid

Acid value (mg KOH/g) 150-250

Density g/cm³ (23℃) 1.00-1.30

Viscosity cps (25℃) 100-800

Active ingredient (%) 100

STORAGE and TRANSPORT

Layering and turbidity may occur at temperatures below 10˚C. Heat to 20˚C and mix thoroughly before use.

Storage time is not recommended to exceed 12 months.

SPECIAL NOTES

This product should be stored in airtight containers and should not be re-stored after pre-dilution.

ATTENTION

Because of its high acid value, the additive may potentially accelerate the reaction of baking systems. Check the increase in viscosity during storage is necessary.

APPLICATION GUIDELINES

Coating Industry

Properties and Advantages.

Anjeka-6111 is mainly used in high solids and solvent-free coatings. Due to its anionic properties, it is well suited for acid-catalyzed systems (e.g. coil coatings). Anjeka-6111 stabilizes inorganic pigments, especially titanium dioxide, which increases gloss, reduces haze, and considerably reduces the viscosity of the abrasive, and it can be used in conjunction with pigment pastes stabilized with the Anjeka range of additives. It can be used with pigment pastes stabilized with Anjeka additives.

APPLICATION SECTORS

Industrial coatings

Automotive coatings

Coil coatings

Anti-corrosion coating systems

●--Special Recommendations; ○--Recommendations

RECOMMENDED LEVELS

The amount of additives (in purchased form) is based on the pigment:

Inorganic pigments: 2%-5%

Titanium dioxide: 1%-3%

The above data are empirical, the optimum dosage should be determined by a series of tests.

INCORPORATION AND PROCESSING INSTRUCTIONS

In order to obtain the best performance, the additives should be added to the abrasive before the pigments.

PACKING

-25kg iron drum with inner coating

-180kg ring plastic drum

Our service:

Our team:

Our company:

Our Certifcate&Patents: